- Height of the bull centre
- 1.73 m (5 ft 8 in)
- Oche, steel tip
- 2.37 m (7 ft 9¼ in)
- Diagonal, steel tip
- 2.93 m (9 ft 7⅜ in)
- Oche, soft tip (often)
- 2.44 m (8 ft)
For darts to fly at home just as they do at the club or on TV, the same three measurements apply everywhere. They are set in the rules of the World Darts Federation (WDF) and the PDC and hold for every board, in the games room just as on stage.
Side view: the centre of the bull hangs 1.73 m above the floor, the oche is 2.37 m in front of the board, and the diagonal from the bull centre to the oche measures 2.93 m.
How high is a dartboard?
The centre of the bullseye hangs 1.73 m (5 ft 8 in) above the floor, measured straight up from the floor at the oche. So you measure to the centre of the bullseye, not to the top of the board and not to the hanging point.
The height is the same for steel tip and soft tip. On dart machines it is usually set already; on a wall you measure it yourself. The top edge of a steel tip board, 45.1 cm across, then sits at about 1.96 m.
Front view: the centre of the bull hangs 1.73 m above the floor, the top edge of the board at about 1.96 m. The board is 45.1 cm across, with the 20 at the top in the middle.
What is the distance to the dartboard?
In steel tip darts the throw line, the oche, is 2.37 m (7 ft 9¼ in) from the board. You measure level along the floor: from the point directly below the face of the board to the edge your toes must not cross when you throw.
The diagonal is your check: from the bull centre to the floor at the oche it is 2.93 m (9 ft 7⅜ in). If height and distance are right, so is the diagonal. If it is off, the floor is uneven or something was measured at an angle.
Soft tip: 2.37 m or 2.44 m?
For soft tip (electronic) darts the bull also hangs at 1.73 m. For the distance there are two standards: many machine makers and international soft tip leagues use 2.44 m (8 ft), which makes the diagonal about 2.99 m. German electronic darts leagues have thrown from 2.37 m since 2016, the same as steel tip.
If you play in a league, use its distance. Without a league, 2.37 m is the best choice: you practise for steel tip at the same time.
How to hang a dartboard, step by step
- Pick the spot: a solid wall with no doors or walkways in the line of throw and a good 3 m of clear space in front of it. The calculator below tells you whether your room is deep enough.
- Mark the height: measure 1.73 m up from the floor and mark it. That is the centre of the bull, not the hanging point.
- Fix the bracket: if the bracket sits exactly in the middle of the back of the board, the screw goes on your mark. If it sits elsewhere, measure the offset on the board and transfer it to the wall.
- Hang the board and turn it so the 20 is at the top in the middle. The 20 is always on a dark segment.
- Mark the oche: measure 2.37 m along the floor from the face of the board (soft tip 2.44 m, depending on the league) and tape the line across, or fit a raised oche.
- Check: measure diagonally from the bull centre to the oche at floor level. 2.93 m means everything is right.
Your board hangs in a surround and its face is 5 cm in front of the wall. The oche is then 2.42 m from the wall, because you measure from the board, not from the wall.
How much space do I need?
In depth you need the board itself (about 5 cm with its bracket), the 2.37 m to the oche and room to stand behind it. With 60 cm behind the line it is tight. It gets comfortable with a good metre; the PDC rules ask for 1.20 m on stage. That adds up to at least about 3.02 m, or 3.62 m to be comfortable.
In width, about 1 m is enough for one player so the throwing arm is free; on stage the area at the oche is at least 1.20 m wide. Keep anything fragile away from the board, as stray darts sometimes land a hand's width off.
Top view of the throwing lane: 5 cm for the board, 2.37 m to the oche, and behind it at least 60 cm, comfortably 1.20 m, of standing room. That adds up to 3.02 m, or a comfortable 3.62 m, from the wall, about 1 m wide.
The ceiling has to be higher than the top of the board, so more than about 1.96 m. If a light hangs above it, allow for that too.
Calculator: enter the depth of the room and the ceiling height in centimetres. For steel tip (2.37 m) and soft tip (2.44 m) it shows whether the board fits comfortably, only just, or how many centimetres are missing. It allows 5 cm for the board, 60 cm of standing room as the minimum and 1.20 m behind the line as comfortable.
Lighting: bright and without shadows
A single ceiling light behind the thrower casts the darts' shadows right onto the board. Light from the front and above, close to the board, works better. At tournaments every board has its own light, shielded so it does not dazzle the players at the oche.
- Ring light: an LED ring around the board lights it evenly from all sides, casts almost no shadows and needs no space on the ceiling. The first choice for home.
- Two spotlights: aimed at the board from the upper left and right. Their shadows cancel each other out. Good for darts corners with a cabinet.
- One lamp above the board: better than nothing, but there is a shadow under every dart. Hang it a little in front of the board, not directly above it.
Three boards with three darts each: a ring light casts hardly any shadows, with two spotlights from the upper left and right the shadows cancel out, and a single lamp above the board casts a long shadow under every dart.
Neutral white light shows the red and green of the board best. Check from the oche whether a lamp dazzles you.
Wall protection, surround and floor
A surround is a foam or plastic ring around the board. It catches stray darts and protects the wall and your points. A cabinet also protects the wall behind the board and often has room for a chalkboard. Without either, a cork or soft fibre board behind the dartboard helps.
On the floor, a dart mat protects falling points. Many mats have the oche lines for steel and soft tip printed on. Still check with a tape measure that the mat sits right. Without a mat, a strip of tape or a screwed-down oche will do.
In a flat, a surround softens the misses, and a board between dartboard and wall keeps the noise away from the neighbours.
Surround, cabinet and dart mat: the surround is a ring around the board that catches stray darts. The cabinet also protects the wall behind the board and often has a chalkboard in the door. The dart mat protects the floor and your points and has the oche lines for 2.37 m and 2.44 m printed on.
Cabinet or open wall?
| Question | Cabinet | Wall with surround |
|---|---|---|
| Wall protection | All round, including behind the board | In the ring around the board |
| Space needed | The doors need room at the sides | Narrower |
| Lighting | Spotlights on the cabinet | A ring light fits well |
| Extras | Chalkboard, space for darts | Quick to move |
Rotating and caring for the board
Most darts land in the 20 and its neighbours. To keep the sisal fibres there from fraying, turn the board on a little every few weeks. If it has a removable number ring, put the ring back afterwards with the 20 at the top. Sisal does not like water: do not wet it or wipe it with a damp cloth.
And for children?
There is no official height for children; the rules only know 1.73 m and 2.37 m. For practice you can hang the board lower and bring the line closer. A lower start score, which you can set in CountDarts, also makes it easier: game setup.
And for scoring?
Once the board is up, all you need is a scorer. CountDarts works out scores left, checkouts and averages and runs on phone, tablet and laptop. For your darts corner, put the score up large on the TV: TV view.
Frequently asked questions
Is the height measured to the centre or to the top of the board?
To the centre of the bullseye: 1.73 m above the floor. The top of the board is then at about 1.96 m.
Is the distance measured from the wall?
No, from the face of the board. If it sits 5 cm in front of the wall, the oche is 2.42 m from the wall.
How long is the diagonal?
From the bull centre to the oche at floor level it is 2.93 m for steel tip. With a 2.44 m distance it is about 2.99 m.
What distance applies to soft tip darts?
Many machines and international leagues use 2.44 m, German electronic darts leagues 2.37 m like steel tip. The height is always 1.73 m.
How much space does a dartboard need?
In depth at least about 3 m from the wall, a good 3.6 m to be comfortable. About 1 m in width, and the ceiling must be higher than 1.96 m.